Perfect for making two rooms out of one, the Mounted Straight Divider with Door includes everything you need to assemble a sleek, modern, new modular wall with a door anywhere in your home.

To assemble, simply screw the included Wall Mounting Bracket into your existing wall before nesting the lightweight panels into the bracket. From there, it's as simple as inserting connectors into the receiving holes on each panel and snapping the panels together like life-sized puzzle pieces!

Need a custom size? Contact Us via live chat, email, or phone!

Our signature Wall and Anchor Panels are 3" thick and made of Moisture and Impact Resistant Fiberglass. For Wall Dividers over 11' in width, 12" wide perpendicular anchoring panels are included to provide additional stability. All Wall and Anchor Panels snap together easily using Lug and 2-Way Connectors for a stable and secure fit.

The Wall Mounting Brackets allow you to easily attach your new Wall Divider to your existing walls. Made of PVC, the bracket is designed to be strong yet flexible and easy to drill into.  Simply drill two holes through the bracket into your wall, insert the included screws, nest the panels into the corner of the bracket, and add two more screws into the side of your panels. For detailed instructions, see the "assembly" tab above.

The included Accordion Door Kit is 36" wide and spans the height of your wall. The Kit includes the lintel, which snaps into the top of your panels using the finishing caps, as well as a two-sided frame, handle, track lubricant, and the door itself. Made of premium PVC, the door is commercial-grade and very sturdy. After lining the doorway with included finishing caps, the frame is easily screwed into the caps for a simple installation.  Finally, the kit also includes an integrated magnet to latch the door in position when closed.

For detailed instructions on the door installation, see the "Assembly" tab above.

Your kit includes Lug Connectors, which snap into the side of each panel and make for an extremely secure two-way connection between panels.

Panels are held together using Lug Connectors, but also 2-Way Connectors which keep them attached at the top and bottom. Just like the Lug Connectors and Finishing Caps, these connectors snap securely into the receiving holes found on all Everpanel panels. 

Finishing caps are used to close off any exposed connector holes, giving the exterior of your wall a clean, finished look! Your kit includes enough caps to seal off the entire perimeter of your wall. For walls above 6'6" in height, finishing caps for the top are not included, as the top is out of view. Extra finishing caps can be purchased from our 'Accessories' page.

Because this model is attached on both sides to your existing walls, you'll want to measure your space. 

1. Ceiling height: Your ceiling should be at least 2 inches higher than the height of the wall you're purchasing.

For example, the minimum ceiling height for the 8' wall to be assembled comfortably is 8'2". Do not try to fit an 8' wall under an 8' ceiling, without a small gap it will be impossible!

2. Wall-to-wall width: The included wall mounting brackets are 3"x3" wide. This gives you around 1" of leeway (0.5" on each side) when it comes to the maximum width of your space from wall-to-wall.

For example, if you're looking at the 138" wall kit, the wall-to-wall width of your space can be anywhere between 138"-139".

3. Floor width: The width of your room along the floor (from the inside of the baseboard on each side) should be no less than the width of the wall you're purchasing.

For example, if you're looking at the 138" wall kit, from baseboard-to-baseboard should be no less than 138".

Do also make sure to check your floor for dips and bulges. Uneven flooring can impact the installation of your product.

Have a question about measurements? Your space doesn't seem to fit any of our available sizes? Contact us, we probably have a custom configuration that works for your space!